Rocktron MultiValve Manual do Utilizador descarregar pdf (Página 68)

Using the MultiValve with a Rocktron All Access



in REMOTE mode

A Rocktron All Access

™

MIDI footswitch can be configured as a dedicated remote control for the MultiValve—

allowing direct access to specific MultiValve features and parameters from the footswitch at any time.

To use an All Access footswitch as a dedicated remote, connect the MIDI OUT of the All

Access to the REMOTE jack of the MultiValve using a 7-pin MIDI cable, as shown below.

Step 1

Step 2

Reinitialize the controller assignments as shown on page 62 under the heading "Restoring the

MultiValve Controller Assignments". This will match up the MultiValve's controller assign-

ments to the All Access. A code of "243" must be entered to initialize

only the controller

information.

ALL RESTORE 243

To set up the MultiValve for remote operation, do the following:

Operating the MultiValve

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 74 75 76

Sem comentários

Rocktron MultiValve Manual do Utilizador Página 68