Rocktron Intellifex XL Manual do Utilizador descarregar pdf (Página 13)

Mixer Parameters

Parameter Description

EFFECT LVL

This controls the level of the entire effect signal. This control should be

set relative to the levels of the Left and Right Direct signals. In configu-

rations which do not include a master Effects Level, the single effect

level parameter (Chorus Level, Delay Level, etc.) is considered the

master Effect Level control.

L/R DIR LEVEL

These controls allow for the left and right Direct signal levels to be set

individually, thereby allowing for panning of the Direct signal to the left or

right output. These controls are available in all configurations.

DIRECT HUSH

This determines whether the direct signal passes through the digital

HUSH

section of the Intellifex XL or bypasses it. Selecting "Post" will

pass the Direct signal through the HUSH

system while selecting "Pre"

will bypass this section. (Note: Selecting "Post" converts a stereo direct

signal to mono.)

CHORUS LVL,

In configurations which include a Master Effects Level control, these

DELAY LVL,

control the level of each individual effect (Chorus, Reverb, etc.).

REVERB LVL,

These should be set relative to each other when defining individual

etc.

levels. In configurations which do not include a Master Effects Level

control, the individual effect level acts as a Master effect level.

REGEN L/R

Configurations which include chorus or delay effects provide individual

left and right regeneration level controls to determine the number of

times the delayed signals are repeated. Regeneration is achieved by

feeding the delayed output back into the input. Higher levels of regen-

eration will result in more repeats.

Note that the Intellifex XL provides

Regeneration Limiting.

This feature

guards against the possibility of overloading the processor when using

high regeneration levels in configurations where a combination of

multiple voices is panned to the left or right. If the regeneration level is

set too high, the Intellifex XL triggers the Regeneration Limiting and a

limit is internally set for the regeneration. This limit can not be exceeded

by increasing the

Regen L

Regen R

parameter values in the Mixer

section.

If, for example, in the

Hush; Chorus; Delay; Reverb

configuration, Voice

1 is panned to the left and the

Regen L

parameter is set to its maximum

level, panning a second voice to the left regeneration loop will trigger the

Regeneration Limiter and reduce the regeneration to a level such that

runaway regeneration will not occur. The original regeneration level can

be reset only by recalling the preset, or, by accessing the

Regen L

parameter, decreasing its value and setting it back to its original value

after removing the second Voice from the regeneration loop. This

feature of the Intellifex XL is particularly desirable in live situations

where panning and regeneration levels may be controlled by continuous

controllers.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 57 58

Comentários a estes Manuais

Sem comentários

Rocktron Intellifex XL Manual do Utilizador Página 13

Comentários a estes Manuais

Manuais e produtos relacionados com Áudio Rocktron Intellifex XL